میکروکنترلر 8 بیتی میکروچیپ با فلش 1.75 کیلو بایت و رم 64 بایت و فرکانس کاری 20 مگاهرتز 14-Pin, Flash-Based 8-Bit CMOS Microcontroller
دریافت کتابخانه( ALITUM DESIGNER )
:High Performance RISC CPU
Only 35 instructions to learn
All single-cycle instructions except branches
:Operating speed
DC - 20 MHz oscillator/clock input
DC - 200 ns instruction cycle
:Interrupt capability
8-level deep hardware stack
Direct, Indirect, and Relative Addressing modes
:Special Microcontroller Features
Internal and external oscillator options
Precision Internal 4 MHz oscillator factory
calibrated to ±1%
External Oscillator support for crystals and
resonators
5 μs wake-up from SLEEP, 3.0V, typical
Power saving SLEEP mode
Wide operating voltage range - 2.0V to 5.5V
Industrial and Extended temperature range
Low power Power-on Reset (POR) Power-up Timer (PWRT) and Oscillator Start-up Timer (OST) Brown-out Detect (BOD) Watchdog Timer (WDT) with independent
oscillator for reliable operation
Multiplexed MCLR/Input-pin
Interrupt-on-pin change
Individual programmable weak pull-ups
Programmable code protection
High Endurance FLASH/EEPROM Cell
100,000 write FLASH endurance
1,000,000 write EEPROM endurance
FLASH/Data EEPROM Retention: > 40 years
:Low Power Features
:Standby Current
1 nA @ 2.0V, typical
: Operating Current
8.5 μA @ 32 kHz, 2.0V, typical
100 μA @ 1 MHz, 2.0V, typical
Watchdog Timer Current
300 nA @ 2.0V, typical
: Timer1 oscillator current
4 μA @ 32 kHz, 2.0V, typical
:Peripheral Features
12 I/O pins with individual direction control
High current sink/source for direct LED drive
:Analog comparator module with
One analog comparator
Programmable on-chip comparator voltage
reference (CVREF) module
Programmable input multiplexing from device inputs
Comparator output is externally accessible
Analog to Digital Converter module (PIC16F676) 10-bit resolution
Programmable 8-channel input
Voltage reference input
: Timer0
8-bit timer/counter with 8-bit
programmable prescaler
: Enhanced Timer1
16-bit timer/counter with prescaler External Gate Input mode
Option to use OSC1 and OSC2 in LP mode
as Timer1 oscillator, if INTOSC mode selected
In-Circuit Serial ProgrammingTM (ICSPTM) via two pins
آیسی دوبل تقویت کننده دیپ 14 ای سی تقویت کننده،اپ امپ 2 تایی با پهنای باند 4 مگاهرتز و ولتاژ کاری 18± ولت General purpose JFET quad operational amplifiers,DIP-16
مبدل DAC ، تبدیل سیگنال دیجیتال 8 بیت موازی به سیگنال آنالوگ ،ولتاژ کاری 5 تا 15 ولت 8-BIT MULTIPLYING DIGITAL-TO-ANALOG CONVERTERS
مقاومت5 % کربنی 1 وات
ترانزیستور PNP ولتاژ 45- ولت 100 -میلی آمپر Bipolar Transistors - BJT -45V,-100mA PNP TRANSISTOR